Whistling from my JLab ANC earbuds
Whistling on ANC Products
Much like when a microphone at a concert or during karaoke can sometimes create a distinct high-pitched whine or screech, earbuds that are actively using their on-board microphones for noise cancelling or pass through, can experience this issue.
This disruptive noise, also known as a positive acoustic feedback loop, occurs when the microphones and speakers play a loop of sound back into each other at certain volumes and frequencies. Microphones are typically located on the outside of the majority of audio products for ANC so they can actively monitor and cancel sound. Not having a good seal for separating these two components can result in a sharp noise that can occur in any product from any manufacturer.
What causes this and how can I prevent this?
Having the earbuds enclosed or creating an environment that restricts them from the open air, can create this high-pitched noise.
- This can increase the chances that the microphones pick up the sounds produced by your earbuds, creating a feedback loop.
- When using the Noise Cancelling or Be Aware features, do not cup your hands around the earbuds.
- When adjusting them, try not to cover the entire audio device. If you need to adjust your earbuds when in your ears, try pinching or lightly adjusting them instead.
Feedback can also be caused when the microphones experience rubbing/direct contact.
- Make sure that the microphones are not obstructed or rubbing on anything.
- You can also use can compressed air to lightly clean the microphones of any dust or debris.
- The JLab Cleaning Kit can be used along with lukewarm water and a small amount of mild dish soap to clear any stubborn debris.

Feedback can also occur when earbuds are left lying around and not properly stored in the charging case or if the earbuds stay connected while inside of the case.
- This can be prevented by placing the earbuds in the correct charging case slot so that they make good contact with the metal pins.
- The charging pins within the case can be safely cleaned with 70 - 90% isopropyl alcohol.
- Make sure the charging contacts on the earbuds are cleaned with soft brush, lightly dampened with lukewarm water and mild dish soap.
- The charging pins within the case can be safely cleaned with 70 - 90% isopropyl alcohol.

Poor seals can also lead to feedback, where if the audio device is not sealed properly, audio can leak into the ANC microphones.
- This is usually caused by using ear-tips that are poor fitting, or not having headphones adjusted to the correct size.
- Ensure that you have tried all of the included earbud tips included in the packaging to find a size that provides the best seal.
- You can also try the JLab Cloud Foam Universal Earbud Tips for greater sound isolation.

If the issue persists, please contact JLab Support for further assistance.
Need help? Contact JLab Support: support@jlab.com or 1-405-445-7219.