Back to Go Party Support Page

How to Use LabSync With GO Party

LabSync lets your GO Party play in sync with other JLab Party speakers, including Pop Party, JBuds Party, and Epic Party. One speaker uses Cast mode while connected to your phone. The other speakers use Receive mode and follow it.

You do not need the JLab app. On GO Party, use the top volume wheel (the center control with the JLab logo) and the power button.

Cast mode

Use Cast on the speaker that stays connected to your phone.

  1. Connect GO Party in your phone's Bluetooth settings.
  2. Press and hold the volume wheel for about 2 seconds. GO Party says "LabSync" and enters Cast mode.

GO Party connected to Bluetooth, then hold the volume wheel for 2 seconds to cast

Receive mode

Repeat these steps on each extra Party speaker you want in the group (GO Party or another model).

  1. With that speaker powered off, press and hold the power button for about 8 seconds, until the light flashes blue and red.
  2. Press and hold the volume wheel for about 2 seconds. That speaker enters Receive mode and joins the Cast speaker.

Hold the GO Party power button 8 seconds, then hold the volume wheel 2 seconds to receive

When the group is connected, the casting speaker's light is blue and each receiving speaker's light is red.

Casting GO Party with a blue light and receiving speakers with red lights

Leave LabSync

  • To leave LabSync, turn the speaker off, then back on.
  • Turning off the casting speaker first also turns off the receiving speakers in the group.

Optional: JLab app

The app is not required for LabSync. Use it if you want to set left, right, or stereo, or to sync volume and lighting before you start. Speakers disconnect from the app while LabSync is on, so change those settings first.

Shared app steps for every Party speaker are in How to Use LabSync With JLab Party Speakers.

Need help? Contact JLab Support: support@jlab.com or 1-405-445-7219.